A Honda wearing VERTEX AXIS gains a coordinated red blue appearance without losing the practical clarity needed from race graphics. Personalisation is part of the composition from the beginning. The layout is not simply enlarged or reduced, because every submitted model and year requires its own panel decisions.
VERTEX AXIS fit and personalisation
A VERTEX AXIS order moves from bike identification to artwork, not the other way around. The Honda model, year, capacity and any non-standard plastics are checked first. Only then are the name and number set into the available areas. This keeps the design recognisable while respecting the selected bodywork.
21 mil layered motocross material
Approximately 21 mil of material sits between the printed face and prepared plastic: 6 mil of aggressive adhesive media below and 15 mil of clear protective laminate above. Air-release channels help control the first placement. The outer layer then provides the main defence against ordinary scuffing, roost, sun and cleaning.
Compatible kit coverage
For the chosen plastic generation, VERTEX AXIS is supplied across the main compatible components rather than as one small accent. Coverage commonly spans plates, radiator panels, airbox sections, both fenders, fork protectors and swingarm zones. The name and race number are incorporated during setup, with extra artwork assessed separately.
Preparation and colour note
Install VERTEX AXIS only after old glue, grease, wax and silicone have been removed from the plastics. Test alignment before firm pressure and use moderate heat around difficult curves rather than stretching the vinyl aggressively. Screen settings and real lighting can make printed colours appear slightly different from the preview.
